C21UE001-2008
28
1.5.
Installation Environment
1.5.1.
Operation Environment
The design of this product is based on the use of indoor environment. If it
cannot meet the requirements of the operating environment, it may cause the
service life of the product to be shortened or even cause safety problems.
Before using the robot arm, make sure that the operating environment meets
the relevant requirements to maintain the stability and service life of the robot
arm.
RS405-LU robot does not meet the clean room environment, and additional
equipment is required to meet the clean room environment.
Environment conditions
Operating environment
Ambient temperature
5
℃
~ 45
℃
[Note 1]
Environment humidity
20%~75% R.H. (No condensation)
Installation method
Upright
Input power
Single phase 50/60Hz 200~240VAC
Allowable height
Altitude 1,000m below
[Note 2]
Allow vibration
0.5G(4.9m/s
2
) below
other
Do not contaminate flammable or corrosive
solvents or gases.
Install indoors to avoid direct sunlight.
Avoid dust, oil mist, salt, metal powder or other
contaminants.
Keep away from water and high humidity.
Avoid shock or vibration.
Keep away from sources of electromagnetic
interference.
Placement at a higher altitude will result in
reduced performance.
[Note 2]
[Note 1.]
When the arm is stopped for a long time on the rest day, there may be a
large resistance when it is ready to run. It is recommended to warm up at a
low speed.
[Note 2.]
Performance will be reduced by about 10% at altitudes above 1000m.
The robot arm is not suitable for use in harsh environments such as coating. If it
Summary of Contents for SCARA Robot RS405-LU
