Hitec Luxembourg S.A. |
5, Rue de l’Église, L-1458 Luxembourg
www.hitec.lu | [email protected] | Tel.: (+352) 49 84 78 - 1 | Fax. (+352) 401303
File Name: HTCA_003-DADS-UserManual.docx
Document Type: End User Manual | Version date: 01/05/2010 | Last Printed: 15/02/2011
Page 58/81
Following you will find a more detailed description of the test parameters.
Test Name
The name of the test.
Group
The group the quality owns to.
Quality
The name of the quality.
Data path
The path where the result file is located.
Method
The ASTM measurement method. Either "OAN" or "COAN".
Class
The class of the carbon black type to be tested. Either "Hard" or "Soft".
Weight
The mass of carbon black to be used for the measurement.
Min Ratio
The minimum ratio "Max torque / TLS" for a measurement to be valid.
Test
parameters
The set of test parameters determining the start and end conditions of the
measurement and the polynomial. These tables can be generated and
changed in the HITEC Config application.
Moisture table
The moisture table used for the moisture correction after the
measurement.
Master curve
The master curve file name containing the master curves displayed on the
graph.
Comment
User comment.
Target value
The target value of the measurement.
Min
temperature
The minimum temperature the measurement should be made with.
Max
temperature
The maximum temperature the measurement should be made with.
In case the Absorptometer type H (DABS) is used, a measurement sequence can be
defined. Six different parts can be defined.
Time
Time in seconds until the specified sequence part will take.
Motor speed
The speed of the motor during this part.
Burette speed
The debit of the burette during this part.
Quantity
The actual quantity (ml/100g) of liquid filled out until the end of the
specific part.
% Target value
Percentage of target value reached until the end of the specific part.
