Hitec Luxembourg S.A. |
5, Rue de l’Église, L-1458 Luxembourg
www.hitec.lu | [email protected] | Tel.: (+352) 49 84 78 - 1 | Fax. (+352) 401303
File Name: HTCA_003-DADS-UserManual.docx
Document Type: End User Manual | Version date: 01/05/2010 | Last Printed: 15/02/2011
Page 79/81
Glossary
Absorptometer type B
manufacturer: Brabender
mechanical toque measuring system (see appropriate
descriptions)
Absorptometer type E
manufacturer: Brabender
electronic torque measuring system (see appropriate
descriptions)
Absorptometer type H
Manufacturer:
HITEC Luxembourg
electronic torque measuring system with additional features
(see appropriate descriptions).
Burette Speed [ml/min]
The debit of the burette.
Class
2 classes are defined so far: HARD is for high structure blacks
and SOFT is for low structure blacks. Determines in which
normalization table the correction values are taken from.
DABS
See ABSORPTOMETER type H.
DBP value as per ASTM
(Proc. A)
Classic method where the DBP value is determined when the
torque curve is reaching the TLS value. This method is called
Procedure A.
DBP value as per 70%
(Proc. B)
The DBP value is determined at the point where the torque
curve reaches 70% of the maximum torque measured during
the mixing run.
Maximum Torque
The highest observed value for the torque on the retained
curve of the mixing run.
Minimum Torque
The torque raw data must exceed this value before the system
starts to look for an automatic stop of the mixing run.
Method
OAN or COAN
The sample is prepared according to D2414 (OAN - Normal)
or D3493 (COAN - Compressed). Determines in which
normalization table the correction values are taken from.
MIXING CURVE
A set of the raw data values for torque and DBP quantity, the
torque values as they come from the Absorptometer type B, E
or H.
