OPERATOR'S STATION
1-82
ADJUSTING THE SEAT (HEATER SEAT OPTIONAL)
Seat Height and Angle Adjustment
Seat height adjustment range is 60 mm (2.4 in) with steps
every 15 mm (0.6 in) (5 positions in total). Moreover, the
height of the front part and the rear part of the seat are
adjusted independently, thus allowing the angle of the seat
to be adjusted.
d
WARNING: Avoid possible injury while operating
lever (1). When pushing down lever (1), do not grab
it. Fingers may be pinched between lever (1) and the
seat stand. Be sure to push on the upper face of lever
(1).
Use lever (1) to adjust the seat height and/or seat angle as
follows:
• To adjust the front part of the seat:
Push down lever (1) while sitting on the seat, and apply or
remove body weight to obtain the desired height. When
the desired height is obtained, release lever (1).
• To adjust the rear part of the seat:
Pull up lever (1) while sitting on the seat, and apply or
remove body weight to obtain the desired height. When
the desired height is obtained, release lever (1).
Console and Seat Fore-aft Adjustment
Pull lever (2) to the right to adjust the seat and both right
and left consoles to desired distance from the travel pedals
and levers. Release lever (2) to lock seat and consoles into
position.
f
NOTE: Seat and console fore-aft adjustment range is 120
mm (4.8 in) with steps every 20 mm (0.8 in).
Seat Fore-Aft Adjustment
Pull lever (3) to unlock the seat from both consoles. With
lever (3), slide the seat to the desired distance from pilot
control levers. Release lever (3).
f
NOTE: Seat fore-aft adjustment range is 160 mm (6.3 in)
with steps every 16 mm (0.8 in).
Backrest Adjustment
Pull up lever (4) to release backrest lock. Move backrest to
the desired position and release lever (4).
SS-955
Warning: Possibility
of pinched fingers
Push down with
the palm.
M1U1-01-029
2
1
4
3
Summary of Contents for ZAXIS 450LC-3
