1.10
1 - 9
1.10 INSPECTION AFTER INSTALLATION/ASSEMBLY
The installation and assembly of the instrument are thus completed.
Make a check again on the following items.
(1) Is there any abnormality at the place of installation?
(2) Has the sponge packing used for holding the light source
switching lever during transport been removed?
(3) Has the power voltage been set correctly?
(4) Is the power cord connected correctly?
Is the grounding wire grounded according to the specification?
(5) Is the cord connected correctly between spectrophotometer
main unit and the computer?
(6) Is the printer installed and connected correctly?
(7) Is there any object that cuts off the light beam in the sample
compartment of the spectrophotometer?
Make sure there are no other abnormalities, and close the lid
of the sample compartment in place.
1.11 POWER-ON
Plug the power cord adapter into a power receptacle and then turn
ON the power switch of the spectrophotometer.
1.12 INSTALLATION OF UV-SOLUTIONS PROGRAM
Refer to Chapter 1 in the operation section of the instruction
manual.
