卸除組件的方法
卸除組件的方法
卸除組件的方法
HOW TO REMOVE PARTS
HOW TO REMOVE PARTS
將蔬果箱向上取出。安裝時，請將箱子左右內側突出部分向門框兩旁的凹入的框
架插入，將蔬果箱的邊緣架置在框架上固定。
蔬果保鮮室
蔬果保鮮室
兩手握住兩側的旋鈕往上抬起予以卸除。
安裝時則用兩手往下推。
打開門後，拉出薄滑動盒及滑動盒。
向上取出下層冷凍盒。
安裝冷凍盒時，請將盒子左右突出的部分向門框兩旁的洞角插入固定。
請將滑動盒兩旁的止動裝置插入下層冷凍盒的外側。
已拆下抽屜門時
已拆下抽屜門時
框
Ice Compartment
製冰室
/
Upper Freezer
上層冷凍室
Vegetable Compartment
When the pull-out door has been removed
下層冷凍室
下層冷凍室
Lower Freezer
Slightly lift up the front side of the vacuum compartment case, release the case from
the catch on the door and pull it towards you.
Remove by lifting while holding the knobs on both sides with
both hands. To attach, push down with both hands.
Fully open the door toward you and
lift the small vegetables case as show
above.
Lift the front of the
door toward you,
slowly pull it out and
tilt the door.
Lift the vegetable case to remove.
To install it, insert the protrusion on the left and right back of the vegetable case into the
square hole of the frame and set it so that the edge of the vegetable case rests on the frame.
Height adjustable pockets
真空室
(X System
真空
チルド
)
Frame
框
Frame
輕輕抬起真空室盒前部，將盒從箱門上的掛鉤上放開，往身前把盒拉出。（
23
頁）
Open the door and pull out the slimline slide case and the slide case.
Lift up the lower freezer case.
Vegetable Compartment
Ice Compartment
蔬果保鮮室
Vacuum compartment
Lower Freezer
下層冷凍室
Upper Freezer
上層冷凍室
製冰室
( Pg. 23)
可調式置物架
To install the freezer case, fit both side of the projections on the lower freezer case into the square holes on the frame.
Set the stoppers on both sides of the slide case onto the outer part of the lower freezer case.
Insert the door pocket fully to the end when installing it.
安裝時要徹底插入到最裏面。
固定容器置物架
Fixed door pockets
可調式層架
・
低層架
Height adjustable shelf Lower shelf
Do not wash the vitamin cassette with water.
請勿用水清洗維生素盒。
Slightly lift up the back of the shelf and draw it.
Raise the shelf as shown in figure, and turn it and remove it.
咚
咚
Open the door, lift the case toward you.
Put the case bottom on the frame and set the case.
打開門，向前方取出。
安裝時要將箱底面裝載在框子上。
Stopper
止動裝置
框
Frame
將箱門稍微往上扳
後，再慢慢向外拉
開，讓箱門傾斜。
將箱門向面前側完全打開。
如圖將瑣碎食品整理滑動盒向上推
後拆下。
固定層架
Fixed shelf
往身前拉出來、將右下
2
個地方的鈎脫開卸除。
Draw the shelf, and pull off the two forks
on the lower right and remove it.
翻轉式層架
稍微向上拉出。
Reversible shelf
Slightly lift up and pull out.
稍微提一下層架的裏頭，往身前拉出
如圖，將層架竪起後翻轉、卸除。
冷藏室
Refrigerator Compartment
一邊提起一邊從箱軌上拉出來卸下。
安裝時，將層架的軸沿著箱軌的溝推進去。
下移式便取盒
Descendible case
Draw the Descendible Case while lifting it, and remove it from the rail.
When installing it, align the axis of the case with the groove of the rail and
push it in.
1
2
1
2
3
1
2
How to remove parts
卸除組件的方法
●
Door may damage if drawing the shelf without lifting it.
●
直接把層架拉出會有可能損傷箱門。
When installing the shelf, slide it until it reaches to the interior
wall, then slightly lift up the back of the shelf and push it in.
(
hitch the forks of the shelf to the parts on the back of the shelf)
安裝時，把層架插放到最裏面之後，稍微提一下層架的
裏頭推進去。
（將層架的鈎扣掛在最裏面的配件上）
Caution
注 意 事 項
Caution
注 意 事 項
Name and installation place of parts. ( Pg. 16)
部件的名稱與安裝位置（
16
頁）
__R-SF6800Z.indd 39
2009/10/26 11:17:12
