Hitachi GR2000 Series, Installation Manual

Page: 232 / 410

up the MPLS network must be RP-D, RP-DV or RP-C, RP-CV. RP-A and RP-A1 will
not operate.
In addition, in regard to the conditions of NIFs that support MPLS functions, NIF
conditions that accommodate MPLS backbone circuits are shown in Table 4-47 and
NIF conditions that accommodate MPLS access circuits are shown in Table 4-51
Refer to Figure 4-7 for the location of MPLS backbone and access circuits.
There are non-utilizable RP types depending on the mode of the MPLS protocol used.
These are shown in the table below.
Table 4-46 Protocol types in MPLS and non-utilizable RP types
MPLS protocol mode
and IP-VPN system
Configuration defining mpls
information protocol
parameter setting
RP-C, RP-D RP-CV, RP-DV
LDP(DoD)/CR-LDP mode,
LSP allocation system for
each VPN cr-ldp O
Usable.
O
Usable.
LDP (DU) mode, RFC2547
bis system ldp-unsolicited X
Not usable.
O
Usable.