!"#
CAUTION
(When using batteries)
#
$
Replace only with the same or equivalent type recommended by the manufacturer.
$
Recycle or dispose of used batteries according to your community’s guidelines.
$
Do not use batteries other than those specified, or mix new and old batteries for use: Doing this could
damage the batteries or cause leakage of liquid, which could result in fire, injury or damage to
surroundings.
#
$
Insert batteries as instructed on the remote control: Reversing polarities could burst the batteries or
cause leakage of liquid, which could result in injury or damage to surroundings.
CAUTION
(When using remote control)
#
$
When not using remote control for a long period of time, remove the batteries from it.
$
Do not allow the remote control to fall and do not subject it to impact.
$
Do not splash water on remote control or place it on wet surface: Doing this could cause a
fault.
#
#
#
Wired or Infrared transmission of remote control
#
(1) Wired transmission
Connect the provided remote cable when using the remote control in the following
conditions.
%
When using at least two projectors
Using infrared transmission may cause malfunction, or rewrite the projector
internal data.
%
When the projector is inoperable because of illumination or is affected by remote
control of another device.
%
When projector is operated from a distance or angle which is outside the usable
range of infrared transmission. (see “(2) Infrared transmission” shown below)
#
(2) Infrared transmission
%
Point the signal transmission window at the projector screen to operate.
%
The usable range of infrared remote control is as follows
#
#
Usable range
#
#
Angle: Within 20 degree from top, bottom, left or right of screen
#
#
Distance: Up to 7m from screen
#
#
Inserting Batteries
&
Remove the battery compartment lid.
Push the lid and move it in the direction of the arrow.
'
Insert batteries.
Be sure to match the polarity indications (+,
!
).
(
Close the battery compartment lid.
Names and Functions of Each Part :
Remote Control
