Hitachi DS240, Service Manual

Page: 45 / 174

I
NSTALLING THE
H
ARDWARE
I
NSTALLING AN
HDD A
SSEMBLY
2-3
Installing an HDD Assembly
1. Insert the HDD tray assembly into of the chassis.
2. Push the HDD tray assembly handle closed.
Figure 2-2. Installing an HDD Tray Assembly
Removing a 2.5” HDD from an HDD Tray
1.
Remove the HDD tray. See Removing an HDD Tray Assembly on page 2-2
.
2.
Extend the side of the tray to fully open position as shown to separate the HDD and
tray.
Figure 2-3. Extend the Side of the Tray
WARNING!
Do not force the tray handle closed. If resistance is encountered, check the hard drive is
properly inserted and the hard drives on either side are properly inserted. To prevent damage
while servicing, do not hold the HDD module by the ejector handle.
!
A
B