Hitachi 22LD4200, Instructions For Use Manual

Page: 5 / 38

- 4 -
Preparation
Install Display on solid horizontal surface such as a table or desk.
For ventilation, leave a space of at least 10 cm free all around the set. To prevent any fault
and unsafe situations, please do not place any objects on top of the set.
Use this apparatus in tropical and/or moderate climates.
Installation of device on the wall (Optional)
Step1:
Invert the flat monitor screen and placed it on a flat surface. Remove the foot top cover. Re-
move the back support from the screen. Replace the support with the mounting bracket align
the holes from the bracket with the mounting holes found on the back of the monitor chassis.
Secure the bracket with the same four (4) 4 (mm) head screws.
Step 2:
Choose the wall where the monitor
would be located. Level and mark
with a pencil the four (4) mounting
points found on the wall bracket. Drill
pilot holes for the plastic anchors
then secure the wall bracket with the
four (4) L=32 mm x D=5 mm screws
(supplied).
Step 3:
Raise the monitor with the mounting
bracket attached and slip the top
opening to the safety flange on the
secured wall bracket. Let the monitor
fall in place safely and secure the
two (2) D=4 mm x L=10 mm safety
screws (supplied) with a long screw-
driver for additional security.
Note: Do not over tighten!
EDFNVXSSRUW
IRRWDVVHPEO\
ENG-2200-1547UK-22 INCH TFT IB.p65 03.03.2004, 17:59 4