FRONT OF THE DISPLAY MODULE |
PAGE 8
2.2.2 ALARMS LEDS
Fuel reserve
Lit:
Analogue sensor alarm
Flashing
: Digital sensor alarm
Off
: Without alarm
Battery level
High temperature
Engine start up failure
Overspeeding
Low oil pressure
Auxiliary 1 (freely
programmable)
Auxiliary 2 (freely
programmable)
NOTE
For more details see the Alarms section
2.2.3 CONTACTORS STATUS LEDS (CEM7 + CEA7CC2).
These LEDs only appear active when the switching control unit is connected.
Start up option due to Network Voltage Failure (CEM7 + CEA7CC2)
The M and G symbols on the front of the control unit only appear activated when
the switching control unit is connected.
Network contactor status
Lit
: Contactor active
Flashing
: Contactor in the
connection/disconnection
phase.
Off
: Contactor disconnected.
Genset contactor status
2.1.4 CONTACTOR BUTTONS (ONLY CEM7P MODULE)
Genset contactor
. Enable/disable genset contactor (manual
mode only).
2.2 STATUS LEDS
2.2.1 ENGINE STATUS LEDS
Motor started
Lit
: Engine running detected
Off
: Motor stopped
Preheating
Lit
: Engine preheating activated
Off
: Engine preheating deactivated
Start engine
Lit
: Engine started
Off
: Engine start deactivated
Alternator status
battery charging
Lit
: With engine running, voltage in the
battery charging alternator is detected
Off
: Stopped engine or engine running
without voltage in the battery charging
alternator
