(APPENDIX III) DIMENSIONS, WIRING AND MECHANICAL PARTS |
PAGE 86
Fig.5
Measurements module wiring section 4
To carry out the wiring a cable with a cross-section of 2.5 mm
2
must be used for
+BAT, ARR, PR and PC connections. For the rest of the connections it is
recommended that a cable be used with a cross-section of 1 mm
2
.
Fig.6
Measurements module wiring section 4
ATTENTION
The equipment must be isolated or disconnected before performing this wiring,
there is a risk of danger.
Fig.2
Measurements module wiring section 1
To power the plate it is recommended that a cable be used with a cross-section
of 1 mm
2
.
Fig.3
Measurements module wiring section 2
Fig.4
Measurements module wiring section 3
NETWORK
CONTACTOR
GENSET
CONTACTOR
FUEL TRANSFER
PUMP OR HEATING
ACTIVATION
CONTACTOR
EMERGENCY
STOP
POWER OUTPUTS MAC: 40 A
OVERLOAD AND
SHORT CIRCUIT
CONTACTOR
