7 Before use
7.1 Fitting the magazine to the screwdriver
3
CAUTION
Disconnect the screwdriver’s supply cord from the elec-
tric supply before fitting the magazine.
1. Remove the depth gauge and bit holder from the
screwdriver.
2. Fit the bit into the screwdriver.
NOTE
The bit clicks into position.
3. Push the magazine onto the screwdriver in the de-
sired working position until it is heard to engage.
NOTE
The magazine can be engaged on the tool in
various positions (every 15°).
NOTE
Check to ensure that the screwdriver is set
to “forward” rotation.
8 Operation
8.1 Screw length adjustment
4
1. Adjust the depth gauge to suit the length of the
screws to be driven.
2. Press the button and slide the depth gauge back or
forward.
3. Set the depth gauge to one of the 5 length marks
corresponding to the length of the screws.
NOTE
The correct screw length setting is very im-
portant for trouble-free magazine operation.
8.2 Inserting the screw strip
5
1. Slide the screw strip through the guide and the
channel until the first screw is in position at the mark
or until the end of the strip is flush with the upper
surface of the magazine at the exit opening.
2. Check that the screw strip has engaged by trying to
pull it back gently.
8.3 Setting the optimum screwdriving depth
6
1. Set the optimum screwdriving depth by turning the
thumbwheel.
2. Turning the thumbwheel counterclockwise causes
the screw to be driven deeper.
3. Drive a screw to test the screwdriving depth setting.
Readjust the setting if necessary.
NOTE
Each audible click of the thumbwheel corres-
ponds to an adjustment of 0.2 mm (0.008 inch).
Turning the thumbwheel clockwise causes the screw
to be driven less deeply.
8.4 Moving the screw strip back
7
CAUTION
Disconnect the screwdriver’s supply cord from the elec-
tric supply.
1. Release the strip retainer by pressing the transport
latch.
2. Pull the screw strip back.
NOTE
Alternatively, the screw strip can be pulled
upwards, out of the magazine, without pressing the
transport latch.
8.5 Removing the magazine from the
screwdriver
8
CAUTION
Disconnect the screwdriver’s supply cord from the elec-
tric supply before removing the magazine.
The magazine can be removed by pressing the release
buttons and, at the same time, pulling it away from the
screwdriver.
9 Care and maintenance
9.1 Care of the magazine
NOTE
Dirt and dust (especially from plaster) may have an ad-
verse effect on operation of the magazine.
CAUTION
Do not, under any circumstances, lubricate the
magazine with mineral oil / grease or graphite
sprays. This would increase the risk of malfunctions.
Clean the magazine simply by blowing out the dirt and
dust with compressed air.
9.1.1 Dismantling the magazine for cleaning after
heavy use
9
NOTE
It is recommended that the magazine is cleaned by wash-
ing it out with warm water after a long period of heavy
use.
1. Remove the screw strip as described in the section
“Moving the screw strip back”.
2. Remove the magazine as described in the section
“Removing the magazine from the screwdriver”.
en
4
Printed: 07.07.2013 | Doc-Nr: PUB / 5142544 / 000 / 00
