*2235115*
2235115
English
25
7.9 Installing drive pulley
1. Clean the centering and clamping surfaces.
2. Fit the drive pulley on to the adapter on the saw head.
3. Secure the drive pulley with the flange cover and the clamping screw.
Technical data
Securing screws for drive pulley
110 Nm
Materials
Open-ended wrench, w/f 19
7.10 Rounding off edges on object to be cut
Rounding off edges on the object to be cut is a job for 2 persons.
1. Pass the diamond wire through the hole drilled in the object.
2. Pass the diamond wire over the guide pulley of the wire saw or the wire guide.
3. To round off the edges, pull the diamond wire repeatedly back and forth.
4. Continue rounding off the edges of the object to be cut until the diamond wire pulls
back and forth easily.
7.11 Installing diamond wire
Make sure that the direction of travel of the diamond wire is correct. The arrow on
the diamond wire or the smaller diameter of tapered beads points in the direction of
travel.
To reduce the risk of wire breakage, use only one connector per wire loop.
Summary of Contents for DSW 2005-TS
