![background image](http://html1.mh-extra.com/html/hilti/dsw-2005-ts/dsw-2005-ts_manual_2136364012.webp)
8
English
2235115
*2235115*
order. Make sure that any damage or malfunctions are rectified in a professional
manner before operation commences.
▶
While the product is operating, remain in a location far outside the danger area with
the remote control unit. Make sure that you have the entire working area in clear view
at all times.
▶
Work only when the product and also the wire guides have been securely and firmly
secured to a solid sub-base. A toppling or dropped part can result in serious damage
or injury.
▶
Do not connect the electricity supply until the wire saw has been set up completely.
▶
Entry into the danger zone (e.g. to adjust the pulleys or water supply, hammer in
wedges, etc.) is permissible only after the
Emergency Stop
button has been pressed
and the drive pulley has come to a standstill.
▶
Adhere to the permissible drive unit parameters and recommended guide values for
wire speed and advance speed while sawing.
▶
Use only diamond sawing wires that comply with the requirements of EN 13236. Use
only diamond sawing wires approved for a cutting speed of at least 30 m/sec, with
rubberized or plastic-coated spaces between the beads.
▶
The number of wire breakages experienced can be reduced considerably by using
high-quality diamond sawing wires and wire connectors and the appropriate crimping
tools for fitting connectors.
▶
The diamond sawing wire can become hot, so do not touch it unless you are wearing
protective gloves.
▶
Use only fasteners (anchors, bolts, etc.) of adequate size to secure the wire guides
and the wire saw and to secure the object being cut.
▶
If equipment such as scaffolding, platforms or ladders is used, check that this
equipment complies with regulations, that it is undamaged and set up in accordance
with regulations.
▶
At all times while the saw is in operation, the operator must ensure that no persons
are present in the danger area. This also applies to the area not immediately visible to
the operator, i.e. the area behind or below the object in which the cut is being made.
If necessary, a large area must be cordoned off or security personnel posted.
▶
Stay alert at all times. Monitor the progress of the sawing operation and keep the
cooling water system and the area surrounding the workplace under observation. Do
not operate the product if your full attention is not on the job.
▶
Modifications to the saw system are prohibited. Operate the product only with the
sawing wire mode active.
Summary of Contents for DSW 2005-TS
