Cut Off Saw
350mm
Hire Shops
A powerful 2 stroke petrol cut off
saw capable of cutting to a depth
of 125mm.
Operating & Safety Guide 912
Once the engine has started, squeeze and release
the throttle to release the trigger lock
and set the
throttle in the idling position.
Note that,
if restarting
after a short break,
you do not
need to use the choke.
If the engine floods
push both the blue choke lever
and the decompression valve fully in. Squeeze the
throttle and press the trigger lock button to hold
the throttle open,
then pull the starter handle
repeatedly until the engine fires.
Adjust the angle of the safety guard
to suit the work,
to do this, simply grasp the guard firmly and turn to the
required angle.
Adopt a comfortable, balanced stance that allows
a good view of the cut.
Never use a cut-off saw
when standing on an unstable platform, or on slippery,
uneven ground.
Grasp the machine firmly with both hands and
squeeze the throttle trigger
to bring the wheel up to
speed before starting the cut.
Do not release the
trigger again until the saw is clear of the work.
Use the dust suppression kit to control the dust
created during the cut.
The dust suppression kit must only be used
with diamond wheels, NOT with standard
abrasive wheels.
Let the wheel and saw do the work –
don’t try to
force it through the material.
Keep the saw and/or work as steady as possible.
Keep
the cut straight and do not allow the cutting
wheel to twist
in the cut.
Never push the equipment beyond its design
limits.
If it will not do what you want with reasonable
ease and speed, assume you have the wrong tool for the
job. Contact your local HSS Hire Shop for advice.
Handle the equipment with care.
Avoid dropping it,
knocking it, or otherwise exposing it to damage.
Never expose the equipment to excessive
moisture, dust or dangerous/corrosive chemicals.
Keep the equipment clean.
You will find this less of a
chore if you clean up regularly rather than wait until the
end of the hire period.
If working with very dusty materials, stop work
and clean the saw more frequently.
When not in use,
store the equipment somewhere
clean, dry and safe
from thieves.
EQUIPMENT CARE
BASIC TECHNIQUES
Be sure to use the correct fuel: a 50 to 1 blend of
unleaded petrol and two-stroke oil. Never use any
other type of oil as a substitute for two-stroke oil.
Move the ON/OFF switch into the OFF position.
Wait for the engine to stop and for the cutting
wheel to become stationary.
If the saw is not to be used again,
remove the cutting
wheel
by simply reversing the fitting procedure (see
Getting Started).
Finally,
dust down the saw before returning it.
FINISHING OFF
Code 07116
©HSS Hire Service Group Plc 1999 No. 912/01
Group Office: 25 Willow Lane, Mitcham, Surrey CR4 4TS
Web Site: http://www.hss.co.uk
Contact your local
0845 728 2828
…any comments?
If you have any suggestions to enable us to improve
the information within this guide please fax your
comments or write to the Product Manager at the
address below
Fax: 020 8687 5001
912/01
