![background image](http://html.mh-extra.com/html/hilti/ag-125-13s/ag-125-13s_original-operating-instructions_2135552010.webp)
***** Nur für internen Gebrauch ***** 27.03.2017 / 13:59:03 - H2\DOK-Sprachpaket\System\AG_125-13S-G5\DEU\AG125-13S_POS2
4
English
2.1.2 Safety warnings common for grinding, sanding, wire brushing, polishing or
abrasive cutting-off operations:
▶
This power tool is intended to function as a grinder, sander, wire brush or cut-
off tool. Read all safety warnings, instructions, illustrations and specifications
provided with this power tool.
Failure to follow all instructions listed below may
result in electric shock, fire and/or serious injury.
▶
Operations such as polishing are not recommended to be performed with this
power tool.
Operations for which the power tool was not designed may create a
hazard and cause personal injury.
▶
Do not use accessories which are not specifically designed and recommended
by the tool manufacturer.
Just because the accessory can be attached to your
power tool, it does not assure safe operation.
▶
The rated speed of the accessory must be at least equal to the maximum speed
marked on the power tool.
Accessories running faster than their rated speed can
break and fly apart.
▶
The outside diameter and the thickness of your accessory must be within
the capacity rating of your power tool.
Incorrectly sized accessories cannot be
adequately guarded or controlled.
▶
Threaded mounting of accessories must match the grinder spindle thread. For
accessories mounted by flanges, the arbour hole of the accessory must fit the
locating diameter of the flange.
Accessories that do not match the mounting
hardware of the power tool will run out of balance, vibrate excessively and may cause
loss of control.
▶
Do not use a damaged accessory. Before each use inspect the accessory
such as abrasive wheels for chips and cracks, backing pad for cracks, tear or
excess wear, wire brush for loose or cracked wires. If power tool or accessory
is dropped, inspect for damage or install an undamaged accessory. After
inspecting and installing an accessory, position yourself and bystanders away
from the plane of the rotating accessory and run the power tool at maximum
no-load speed for one minute.
Damaged accessories will normally break apart
during this test time.
▶
Wear personal protective equipment. Depending on application, use face shield,
safety goggles or safety glasses. As appropriate, wear dust mask, hearing
protectors, gloves and workshop apron capable of stopping small abrasive or
workpiece fragments.
The eye protection must be capable of stopping flying debris
generated by various operations. The dust mask or respirator must be capable of
filtrating particles generated by your operation. Prolonged exposure to high intensity
noise may cause hearing loss.
▶
Keep bystanders a safe distance away from work area. Anyone entering the work
area must wear personal protective equipment.
Fragments of workpiece or of a
broken accessory may fly away and cause injury beyond immediate area of operation.
▶
Hold the power tool by insulated gripping surfaces only, when performing an
operation where the cutting accessory may contact hidden wiring or its own
cord.
Cutting accessory contacting a "live" wire may make exposed metal parts of
the power tool "live" and could give the operator an electric shock.
▶
Position the cord clear of the spinning accessory.
If you lose control, the cord may
be cut or snagged and your hand or arm may be pulled into the spinning accessory.
▶
Never lay the power tool down until the accessory has come to a complete stop.
The spinning accessory may grab the surface and pull the power tool out of your
control.