![background image](http://html.mh-extra.com/html/hilti/ag-125-13s/ag-125-13s_original-operating-instructions_2135552021.webp)
***** Nur für internen Gebrauch ***** 27.03.2017 / 13:59:03 - H2\DOK-Sprachpaket\System\AG_125-13S-G5\DEU\AG125-13S_POS2
English
15
5. Press the spindle lockbutton and hold it in this position.
6. Tighten the core bit with a suitable open-end wrench.
7. Then release the spindle lockbutton and remove the open-end wrench.
6.6 Fitting the wire brush
12
1. Disconnect the mains plug from the power outlet.
2. Fit the side handle. → page 12
3. Fit the guard. → page 12
4. Place the wire brush in position and tighten it hand-tight.
5. Press the spindle lockbutton and hold it in this position.
6. Tighten the wire brush with a suitable open-end wrench.
7. Then release the spindle lockbutton and remove the open-end wrench.
6.7 Fitting the abrasive resin-fiber disc
13
1. Disconnect the mains plug from the power outlet.
2. Fit the side handle. → page 12
3. Fit the guard. → page 12
4. Fit the support plate and the abrasive resin-fiber disc, screw on the clamping nut and
tighten it securely.
5. Press the spindle lockbutton and hold it in this position.
6. Use the pin wrench to tighten the clamping nut securely, then release the spindle
lockbutton and remove the wrench.
7 Operation
7.1 Grinding
CAUTION
Risk of injury.
The accessory tool may suddenly stick or stall.
▶
Use the power tool with the side handle (or optional hoop grip) fitted and always
hold the power tool securely with both hands.
7.1.1 Cutting
▶
When cutting, apply moderate feed pressure and do not tilt the power tool or the
cutting disc (when working, hold at approx. 90° to the surface being cut).
Note
For best results when cutting profiles and square tube, start cutting at the
smallest cross section.
7.1.2 Rough grinding
▶
Move the power tool to and fro while maintaining a 5° to 30° angle of attack and
applying moderate pressure.
◁
This will avoid overheating and discoloration of the workpiece and help ensure an
even surface finish.
7.2 Switching on and off
7.2.1 Switching on
1. Plug the supply cord into the power outlet.