Hill-Rom P1190, User Manual

Page: 38 / 62

30 Advanta™ 2 Bed User Manual (157722 REV 2)
Oxygen Tank Holder, E-Size (P27601)
WARNING:
If the oxygen tank holder is placed at the foot end of the bed, make sure the
Knee Up/Down controls are locked out. Failure to do so can cause caregiver,
patient, or visitor injury if the foot section fully lowers and the holder becomes
dislodged from the bed.
CAUTION:
Do not exceed the load capacity of the oxygen tank holder. If the oxygen tank
is overloaded, personal injury or equipment damage may occur.
The oxygen tank holder attaches to the head end of the articulating frame in a vertical
position. The oxygen tank holder accommodates one
E size oxygen tank with a
regulator. The mounting points are located to allow the affixed oxygen tank holder to
pivot.
To Install
• Install the mounting bar vertically into a mounting socket at either the head end or foot end of the
articulating frame. Make sure the Knee Up/Down control is locked out if installed at the foot end.
• Put the tank in the holder, and tighten the holder thumbscrew. The thumbscrew keeps the oxygen
tank from rotating in the holder.
To Remove
• Loosen the thumbscrew that holds the tank in the holder.
• Lift the tank out of the holder.
• Lift up on the tank holder, and remove it from the mounting sockets.
Traction Frame Support (P1181)
The traction frame adapter bracket (P1181) attaches fracture frame equipment to the bed.
WARNING:
Failure to stow the traction frame support, when not in use, could cause a trip hazard.
Refer to the equipment manufacturer’s instructions for installation procedures.
Patient Helper Support (P1191)
The Patient Helper Support (P1191) is used to attach the patient helper to the bed.
Refer to the equipment manufacturer’s instructions for installation procedures.