18
Advanta™ 2 Bed User Manual (157722 REV 2)
When the system is armed and it detects movement off the bed, these occur:
•
An audible alarm comes on.
•
The Out-of-Bed Mode indicator flashes.
•
A priority nurse call is sent. The light and alarm continue until the system is turned off, even if the
patient lies down on the bed.
To Activate
1. Make sure the patient is centered in the bed and aligned with the hip locator.
2. Press the
Enable
control until the indicator comes on.
3. Press the applicable mode control. When the system beeps one time and the indicator stays on solid,
the system is armed.
NOTE:
The indicator flashes until the system is armed.
Patient Position
Bed Exiting Mode
Out-of-Bed
Mode
Mode/Patient
Movement Mode
Enable
Control
If the system does not arm, the system will beep rapidly for a few seconds and the selected mode
indicator will flash. This means one or more of these:
•
The patient weighs less than 50 lb (23 kg).
•
The patient weighs more than 500 lb (227 kg).
•
The patient is not in the correct position.
•
The system has malfunctioned.
To Reset or Deactivate
1. Press the
Enable
control until the indicator comes on.
2. Press any mode control until the indicator goes off.
To Adjust the Alarm Volume
1. Make sure the patient is on the bed and the system is armed.
2. Press the
Enable
control until the indicator comes on.
3. Press and release the
Volume
control until the applicable volume
indicator comes on.
Summary of Contents for P1190
