Hill-Rom P1190, User Manual

Page: 18 / 62

10 Advanta™ 2 Bed User Manual (157722 REV 2)
To Raise
• Grasp the siderail by the top, not by the latch area.
• Pull the siderail up until it latches into the locked
position. A click will be heard when it latches into the
locked position.
• Once the click is heard, gently pull on the siderail to
make sure it is latched correctly.
To Lower
• Make sure there is no weight against the siderail.
• Grasp the release handle and pull up. The siderail
lowers automatically.
Angle Indicators
The head siderails contain the Head Angle Line-of-Site®
Angle Indicators and the foot siderails contain the
Trendelenburg Line-of-Site® Angle Indicators. The angle
is read from the center of the ball. Beds with the 30 degree
head angle alarm will also display the angle on the flip-up
control pod on the head siderails.
WARNING:
Failure to make sure the head section is at the correct
angle for the patient’s care could cause patient injury.
When the angle of the head section is critical to the patient’s
care, do not depend on the head angle display only. Look to
make sure the head section is at the correct angle. If the
angle does not look correct, contact your facility-authorized
maintenance person.
On beds with the control pod and head angle display options, the display is always on and shows the head
angle of the bed unless a weight reading is being taken.
30° Head Angle Alarm
The Head Angle Alarm control is on the caregiver pod next to the display. When set, if the
head section goes below 30°, these will occur:
• The display will flash continuously.
• An audible alarm will come on.
• The alarm indicator will flash.
• If installed, the SafeView® Alerts lights will flash yellow.