Hill-Rom P1190, User Manual

Page: 31 / 62

Advanta™ 2 Bed User Manual (157722 REV 2) 23
6. Decreasing pressure on the transport handles will slow the bed.
7. Releasing the enable switch(es) on the transport handles will cause the bed to stop .
WARNING:
In case of battery or motor power loss, toggle the electronic
brake switch to OFF. This permits manual movement of the
bed with a deployed, unpowered system.
An electronic brake switch is located on the right side of the drive
housing. If during a transport, the battery fails or there is a loss of
motor power, toggle the electronic brake switch to OFF. This
permits manual movement of the bed with the drive mechanism
deployed. Reset the switch at the destination, and inform facility
maintenance of the condition.
To Deactivate
• Set the brake/steer control to neutral or brake.
or
• Plug the bed into an appropriate AC power source.
To Stow the Transport Handles
1. Grasp the handles and lift upwards to unlock them.
2. Swing the handles inward toward the center of the bed into
the stowed position.
The batteries are charged when the AC power cord is plugged
into a wall outlet; therefore, plug the AC power cord into a wall
outlet whenever possible.
5th Wheel Assembly
The 5th wheel assembly is controlled by the brake and steer control.
When the brake and steer pedal is placed in the
Steer position, the 5th
wheel locks inline with the bed frame. When the brake and steer pedal
is placed in the
Neutral position, the 5th wheel swivels freely to allow
the bed to be moved from side to side.
See “Brake and Steer Control” on page 8 for the brake and steer
controls.