Hill-Rom 3301030, Service Manual

Page: 7 / 28

Service Manual LikoGuard™
overhead lift
• 3EN190401 Rev. 7 7 www.hillrom.com
2.2 Error codes - General Information
HandControl LG with display
Advanced menu Error Codes from the HandControl with display:
The error code consists of 4 digits. The first two digits indicate the origin of the failure in the soft ware
(the SW item e.g. the battery handler, motor controller) – table 1.
The second two digits are the type of failure e.g. RTC failure, SPI bus failure. – table 2.
Error Code Examples:
0319 : 03 corresponds to – motor controller
19 corresponds to – over temperature error
=> High temperature in the system
0a0b: 0a is the – battery handler
0b is an – I2C bus error
=> Failure occurred on the battery communication line
TABLE 1
Software item Description
00 Lift Motor driver
01 Transfer motor driver
02 Switch motor driver
03 Motor controller
04 Data storage
05 Pendant handler
06 Real time clock (RTC) handler
07 Sensor handler
08 Power handler
09 Service
0a Battery handler
0b System handler
0c Keyboard handler
0d Charger handler
0e Input/Output (IO) expander
TABLE 2
ID Description
01 Read failure on the SPI bus
02 Write failure on the SPI bus
03 Read failure on the UART bus
04 Write failure on the UART bus
05 Write failure on the I2C bus
06 Read failure on the I2C bus
07 Mutex failure
08 Q failure
09 Eeprom failure
0b General I2C bus error
0c Time out error on the I2c
0d RTC is desyncronised
0e Charging error
0f Charging time out error
10 Inrush error
11 Current difference error
12 Potentiometer calibration error
13 Limit switch error
14 No change in the potentiometer error
15 Lower limit switch failure
16 Upper limit switch failure
17 Active load switch missing
18 Current change invalid
19 Overtemperature error
21 Indicator error for software over current
22 Indicator error for hardware over current
30 Checksum failure
31 Critical data read from eeprom failure
32 Pendant communication failure
33 Pendant power down
FF Error code not defined
Service
Usage
Service Advanced Error Message
Shows the last 10 error messages.
(No.1 is the most recent)
Reset Reset Error Message