User Manual of DS-6500DI–T Universal Network Decoder
27
Configuring Time Sync by NTP Server
A Network Time Protocol (NTP) Server can be configured on your device to ensure the accuracy of system
date/time.
If the device is connected to a Dynamic Host Configuration Protocol (DHCP) network that has time server
properties configured, the camera will synchronize automatically with the time server.
Enable the
NTP
function by checking the checkbox, and configure the following settings:
NTP Server:
IP address of NTP server.
NTP Port:
Port of NTP server.
Figure 4.23 Configure Time by NTP
Note
:
If the device is connected to a public network, you should use a NTP server that has a time synchronization
function, such as the server at the National Time Center (IP Address: 210.72.145.44). If the device is set up in a
more customized network, NTP software can be used to establish a NTP server used for time synchronization.
Configuring Time Synchronization by Manually
Enable the
Manual Correction
function and then click the
icon to set the system time from the pop-up
calendar.
Figure 4.24 Configure Time by Manually
3.
Select the time zone that is closest to the device’s location from the drop-down list.
4.
Click
Save
to save the settings.
4.2.3 Configuring Basic Network Settings
Purpose:
You can set the network parameters for the decoder in the parameter configure interface.
Steps:
1.
Click
Configuration
>
Network Settings
>
General
to enter the general network settings interface.
Summary of Contents for DS-6500DI-T
Page 1: ...Universal Network Decoder User Manual V1 0 0 UD 6L0203D1078A01...
Page 7: ...User Manual of DS 6500DI T Universal Network Decoder 6 CHAPTER 1 Introduction...
Page 9: ...User Manual of DS 6500DI T Universal Network Decoder 8 CHAPTER 2 Panels and Connections...
Page 53: ...User Manual of DS 6500DI T Universal Network Decoder 52 CHAPTER 6 Specifications...