User Manual of DS-6500DI–T Universal Network Decoder
16
4.1 Decoding Operation
4.1.1 Configuring Decoded Video Display
Purpose:
To realize the display of the decoded video on the TV wall, you must set the decoding operation parameters.
Before you start:
Check the cabling of the decoder, and ensure that the decoder is connected to the TV wall or monitor via the
video output interfaces.
To set the video output of the decoder, the first step is to choose the video output interfaces. There are 2 types of
video output interfaces, the BNC and DVI outputs.
Steps:
1.
Click
Decode Operation
>
Decode Mode
>
Display Control
to enter the display control interface:
Figure 4.3 Display Configure
2.
In the display control interface, you can configure the Display Channel, Video Format (BNC), BNC Output
Scaling (BNC), Output Resolution (DVI) and Display Mode.
Figure 4.4 Configure Display Parameters
3.
Select the window-division display mode. The DS-6500DI-T series supports 1/4/6/8/9/12/16-division
display mode.
4.
Select the decoding channel from the drop-down list for each sub-window.
5.
Click
Save
to save the settings and the prompt
pops out.
After having configured the window-division display, the sub-window information can be viewed on the
interface.
Example:
If you select the display mode as 4, the sub-window configuration field shows the status of the four
sub-windows.
Summary of Contents for DS-6500DI-T
Page 1: ...Universal Network Decoder User Manual V1 0 0 UD 6L0203D1078A01...
Page 7: ...User Manual of DS 6500DI T Universal Network Decoder 6 CHAPTER 1 Introduction...
Page 9: ...User Manual of DS 6500DI T Universal Network Decoder 8 CHAPTER 2 Panels and Connections...
Page 53: ...User Manual of DS 6500DI T Universal Network Decoder 52 CHAPTER 6 Specifications...