High End Systems Studio Command 1200, User Manual

Page: 78 / 108

CHAPTER 6
Troubleshooting
68 Studio Command Series User Manual
Status LEDs
Studio Command
™
fixtures have five
Status LEDs on the display panel. The
status LEDs help analyze problems with
the Studio Command fixture
.
1
If you shut down the lamp using a remote shutdown command, the lamp and the Lamp LED will
shut off normally. However, if you have bad data cables, no data cables/controller connected to
the fixture, or the controller is off, the lamp and its LED will also be off. If correcting these prob-
lems does not turn the lamp on, see the next section.
2
Neither the Transmit nor the Receive LED will be on until you have connected the fixture to a
DMX 512-compatible controller using XLR data-grade cabling. If these LEDs remain OFF even
though you have connected the fixture to a controller and are sending DMX 512 commands to
the fixture, see the next section.
LED State
Problem
Indication?
Description
Motor
solid green No The motor power supply is receiving adequate voltage.
OFF Yes Fuse or power failure.
Lamp
(700 model)
solid yellow No
Lamp power is on.
Lamp is striking.
The lamp power supply is receiving the proper voltage,
and the lamp is on.
OFF Sometimes
1
The lamp is extinguished.
Lamp
(H model)
solid yellow No Lamp circuit is closed
OFF Lamp circuit is open
5V
solid red No The logic board is receiving the required voltage.
OFF Yes Fuse or power failure.
Transmit
solid yellow No
Fixture is crossloading software to other fixtures on the
link.
OFF Sometimes
2
DMX 512 data is not being transmitted.
flashing No
The fixture is in preset playback mode, and is the
master fixture or the fixture is a slave fixture receiving
an upload.
Receive
solid or
(flickering green)
No The fixture is receiving data.
OFF Sometimes
2
DMX 512 data is not being received.
Status
LEDs