High End Systems Studio Command 1200, User Manual

Page: 70 / 108

CHAPTER 5
General Maintenance
60 Studio Command Series User Manual
1. Orient the fixture so
that the beam will
project onto a flat, white
surface at least 10 feet
(3 m) away.
2. Turn the lamp on using
the Menu system (see
Turning the Lamp On or
Off (LAMP) on page 33)
or with a console via
DMX.
3. Make sure that the light beam is round and not oval.
4. If necessary, use the following steps in the menu to adjust the pan and tilt construct
values until the beam is round, or set Pan and Tilt values via a DMX console.
Press and hold <Menu> until AddR appears on the LED display.
Scroll to the PRST menu. Press <Enter> to select.
Scroll to the EDIT menu. Press <Enter> to select.
Scroll to a scene number (SN01 – SN16).
Press <Enter> to store.
Select a Pan Value (PAN):
Scroll to the PAN parameter. Press <Enter> to select.
Scroll to a pan value from -49.9 to +49.9 (in this example, +30.5).
Press <Enter> to store the selection.
Select a Tilt Value (TILT):
Scroll to the TILT parameter. Press <Enter> to select.
Scroll to the desired tilt value from -49.9–+49.9 (in this example, -20.3)
Press <Enter> to store the selection.
to
White wall
10 ft. (3 meter minimum)