High End Systems Studio Command 1200, User Manual

Page: 20 / 108

Warning: Class 1 equipment - This equipment must be
earthed.
CHAPTER 2
Setup and Configuration
10 Studio Command Series User Manual
Installing an Attachment Plug - U.K. Only
In the United Kingdom, the colours of the cores in the mains lead of this equipment may not
correspond with the colored markings identifying the terminals in your plug. Therefore, install
an attachment plug in accordance with the following code:
• The core which is coloured green and yellow must be connected to the plug terminal which is
marked with the letter “E” or by the earth symbol , or coloured green, or green/yellow.
• The core which is coloured blue must be connected to the terminal which is marked with the
letter “N” or coloured black.
• The core which is coloured brown must be connected to the terminal which is marked with the
“lateral” or coloured red.
Vigtig Fikker Heds Information - Danmark
Advarsel: Beskyttelse mod elektrisk chock.
Vigtigt!
Lederne med gul/groen isolation maa kun tilsluttes en klemme maerket
Installing the Lamp (Studio Command-H Fixtures Only)
1. Tilt the fixture’s head to access the lamp cap and
using a wide tip, flat head screwdriver, loosen
(but do not remove) the two lamp assembly
screws.
2. Pull the lamp assembly straight out of the
fixture. The lamp assembly is connected to the
fixture by lamp socket wires. Support the lamp
assembly while replacing the lamp. Do not
allow the lamp socket wires to support the
weight of the lamp assembly.
3. Remove all packaging materials from the new
lamp. Holding the new lamp by its ceramic base,
gently press the two base pins into the
B
lamp socket until the lamp is firmly
seated.
Caution: When handling the new lamp, avoid contact with
the lamp glass. If the lamp glass is soiled by oil or
dirt from skin, gloves, etc., clean the cold lamp
glass with an alcohol wipe. A soiled lamp could
overheat and burst, causing damage to the fixture.
eller
A