NGS Mach II User Guide v1.1
9
Getting Started
Vehicle & Power Connections
Use the connector panel for power and communications.
DATA LINK
Connect either the
OBDII/EEC-V Adapter Cable
or the
EEC-IV Adapter Cable
to this port to allow
NGS Mach II to communicate with the vehicle.
AUX POWER
Connect the
Auxiliary Power Cable
to this
port to provide power to NGS Mach II when
using the
EEC-IV Adapter Cable,
the Computer
Interface Cable, or when the VPWR is missing
from the vehicle’s OBDII connector.
PC LINK
When updating the NGS Mach II software,
connect the
Computer Interface Cable
to this port
to allow NGS Mach II to communicate with a PC.
Vehicle Hookup Procedures
Before you begin, make sure the vehicle’s ignition key is in the OFF position, and that NGS Mach II is
not connected to power.
1. Connect the appropriate adapter cable to
the Data Link port.
•
OBDII/EEC V Adapter Cable
—Use to
connect NGS Mach II to a vehicle with an
OBDII connector.
Note: Power is supplied
through the cable via the OBDII connector,
the auxiliary power cable is not required.
•
EEC-IV Adapter Cable
—Use to connect
NGS Mach II to a vehicle with an EEC-IV
(VIP) connector. Requires the Auxiliary
Power Cable.
2. Connect the other end of the cable
connector to the vehicle at the
appropriate port depending on the
cable adapter used (EEC-IV port or OBDII
Connector port).
DATA LINK
AUX
POWER
PC LINK
Auxiliary Power Cable
To vehicle’s power outlet
To NGS Mach II
EEC-IV
Adapter Cable
To NGS Mach II
To vehicle’s
EEC-IV connector
OBDII/EEC V
Adapter Cable
To NGS
Mach II
To vehicle’s
OBDII connector
