NGS Mach II User Guide v1.1
PATS Functions
34
Add New Keys (Ignition Key Code Program)
When the programmed keys are not available, this procedure allows NGS Mach II to add keys to
PATS II systems.
Note: For PATS I systems, or when the programmed keys are available, see
Programming Without NGS Mach II
.
• Make sure to use blank
unprogrammed keys
.
• Make sure the vehicle’s battery is fully charged—disconnect NGS Mach II from the vehicle if the
battery needs charging.
Procedure:
1. Cut the number of keys you want to add
to the vehicle (refer to the vehicle’s shop
manual).
2. Note the module that contains PATS
functionality (refer to the vehicle’s shop
manual).
3. With NGS Mach II connected to the
vehicle, insert an unprogrammed key in
the ignition.
4. Turn the key to
RUN
—do not crank the
engine.
5. At the NGS Mach II main screen, select
the Vehicle, Module, and Action from the
Main menu.
• Select the module that contains the
PATS functionality from the list of
modules (refer to the vehicle’s shop
manual).
6. Highlight
GO
and then press
TRIGGER
.
7. Highlight
SERVICE BAY FUNCTIONS
and
then press
TRIGGER
.
8. Highlight the module that contains the
PATS functionality and then press
TRIGGER
.
9. Highlight
PRESELECT FOR PATS
and then
press
TRIGGER
.
10. When prompted, reselect the following
(press
TRIGGER
after each selection):
• SELECT NEW VEHICLE YEAR & MODEL
• Select model year
• Select vehicle and engine
• Confirm selection
11. Highlight
ENTER SECURITY ACCESS
and
then press
TRIGGER
.
Note: For security purposes, there is an eight
to ten minute delay before you gain access.
12. After gaining security access, highlight
IGNITION KEY CODE PROGRAM
and
then press
TRIGGER
to complete the
procedure.
A message displays at the bottom of the
screen to let you know the process is
complete.
13. Disconnect NGS Mach II from the vehicle.
14. Turn the key to
OFF
.
15. Wait ten seconds and then turn the key to
RUN
.
Repeat the above steps for any additional keys.
Make sure to test the keys to be sure the vehicle
starts.
