NGS Mach II User Guide v1.1
PATS Functions
39
12. Disconnect NGS Mach II from the vehicle.
13. Cycle the ignition key from
OFF
to
RUN
5
times.
• Make sure to leave the key in
RUN
for at
least 3 seconds, and in
OFF
for at least 2
seconds.
The theft indicator should prove out for 3
seconds and the vehicle should start.
Procedure for PATS II Systems with HEC,
VIC, ICM, or PATS Module
1. With NGS Mach II connected to the vehicle
insert the key into the ignition.
2. Turn the key to
RUN
—do not crank the
engine.
3. At the NGS Mach II main screen, select
the Vehicle, Module, and Action from the
Main menu.
• Select the module that contains the PATS
functionality from the list of modules
(refer to the vehicle’s shop manual).
4. Highlight
GO
and then press
TRIGGER
.
5. Highlight
SERVICE BAY FUNCTIONS
and
then press
TRIGGER
.
6. Highlight the module that contains the
PATS functionality and then press
TRIGGER
.
7. Highlight
PRESELECT FOR PATS
and then
press
TRIGGER
.
8. When prompted, reselect the following
(press
TRIGGER
after each selection):
• SELECT NEW VEHICLE YEAR & MODEL
• Select model year
• Select vehicle and engine
• Confirm selection
9. Highlight
ENTER SECURITY ACCESS
and
then press
TRIGGER
.
Note: For security purposes, there is an eight
to ten minute delay before you gain access.
10. After the security delay, highlight
PARAMETER RESET
and press
TRIGGER.
11. When NGS Mach II displays a message that
the process is complete, turn the key to
the
OFF
position.
