Hickok NGS Mach II, User Manual

Page: 31 / 53

NGS Mach II User Guide v1.1
Generic OBDII Functions
31
3. When prompted, reselect the following
(press TRIGGER after each selection):
• SELECT NEW VEHICLE YEAR & MODEL
• Select model year
• SELECT VEHICLE AND ENGINE
• Confirm selection
• GENERIC OBDII FUNCTIONS
4. Select the desired test.
PID DATA MONITOR
FREEZE FRAME PID DATA
DIAGNOSTIC TROUBLE CODES
CLEAR DIAGNOSTIC CODES
OXYGEN SENSOR TEST RESULTS
SELECT ITEM AND PRESS TRIGGER TO START
d
5. Follow the instructions on the screen to run
the test. The results display after the test.
Function Descriptions
Remember, the functions available vary depending
on the vehicle and module selected.
Pid Data Monitor
Allows you to monitor PCM-OBDII supported
PIDs. The screen buttons work this way:
START
*PSG *ENG RPM *SC STS
*VSS *WOT SW MLPR
*TP IDLE SW *ODS STS
*TOT *PWR SW CCS-M
*VPWR SCODC *SSB-M
CLEAR
CLEAR
Deselects all PIDs.
MAX
Selects all PIDs.
START
Begins monitoring. NGS displays the
PID, the data and the node address of
the module sending the data.
Freeze Frame PID Data
Displays the trouble code and its node address
in the left window. The right window displays—
or freezes—PID values corresponding to the
time that the code was set.
The screen is set up this way:
ECT -39
O
F
FUELSYS1 OPEN
FUELSYS2 N/A
SHIFT SOLENOID C -MALFUNCTION
10:P0760
u d
u
or
d
Highlight individual PIDs if more than
one display.
Oxygen Sensor Test Results
Displays test results over two screens. The SAE
defines nine tests. Your Shop Manual defines
tests specific to your vehicle if available. Use the
dial to highlight a test and
TRIGGER
to select.
(1) RICH TO LEAN THRESHOLD VOLTAGE
(2) LEAN TO RICH THRESHOLD VOLTAGE
(3) LOW SEN VOLT FOR SW TIME CALC
(4) HIGH SENS VOLT FOR SW TIME CALC
(5) RICH TO LEAN SENS SWITCH
SELECT ITEM AND PRESS TRIGGER TO START
Oxygen Sensor Test Results display in columns:
SPARK
45.00
45.75
45.75
DEG
BANK MEAS MIN MAX UNIT
(1) RICH TO LEAN THRESHOLD VOLTAGE