NGS Mach II User Guide v1.1
Diagnostic Functions
21
Active Command Modes
1. You can control multiple vehicle devices
from NGS XLC when you select
ACTIVE
COMMAND MODES
. Depending on the
module,
some
of the possible options are:
• Battery Saver
• EGR Control Solenoid
• Front Windshield Wiper
• Fuel Pump Relay
• IAC Valve Opening
• Illuminated Entry
• Output State Control
• Power Balance
• Self-learning Control
• Cooling Fan
• Engine Coolant Temp.
• Fuel Injection
• Heated Backlight
• Ignition Timing
• Interior Courtesy Lamps
2. When you select one of the Active
Command Modes, such as
FRONT
WINDSHIELD WIPER
, NGS XLC displays a
split screen.
3. Press
PIDS
to display PIDs.
4. Press
TRIGGER
to select one PID.
To select a block of PIDs:
• Press
BLOCK
and turn the dial to a PID
to choose a starting point in the PID list.
• Press TRIGGER to lock in the starting
point.
• Turn the dial to highlight the desired
block of PIDs.
• Press TRIGGER to lock in the selected
block of PIDs
• Repeat the above steps to select
additional blocks.
5. Press
START
to display
Active Command
Modes
screen.
The left window reflects changes you make
to the values; it does not reflect the actual
status of the device. For example, you may
have turned a device on and the screen
displays on. However, the device could
be off because the vehicle’s computer
automatically reset it to prevent damage.
6. Press
TRIGGER
to change a value.
The screen buttons work this way:
SETUP
Allows you to select manual
or automatic mode. After
selecting a mode, press
CANCEL
to return to the Active
Command Modes screen:
MAN
Allows you to send the signal
precisely when you decide—by
pressing
SEND
. To change a
value:
• turn the dial to select a value
• press
TRIGGER
• turn the dial to change the
value
• press
TRIGGER
•
AUTO
sends the signal
automatically
• turn the dial to select a value
• press
TRIGGER
to toggle
OFF
and
ON
. AUTO mode
sends the signal as soon as
you change a value.
