NGS Mach II User Guide v1.1
12
Getting Started
Selecting an Action
The final selection before beginning a test is
selecting an action to perform for the vehicle
and module selected.
To choose an action, follow these steps:
1. Highlight
ACTION
and then press
TRIGGER
.
1 )MODEL : 2008 CROWN VICTORIA
4.6L
2)MODULE: PCM -POWERTRAIN CONTROL
3)ACTION : _ _ _ _
4)GO ->
SELECT ITEM AND PRESS TRIGGER TO START
d
2. NGS Mach II displays a list of actions
for the vehicle and module selected.
Highlight the desired action, and then
press
TRIGGER
.
ACTIVE/BI-DIRECTIONAL COMANDS
CUSTOMER PREFERENCES
DTC CODES RETRIEVE / CLEAR
EVAP TESTS
GENERIC OBDII FUNCTIONS
IVD CAL - INTERACTIVE VEHICLE DYNAMI
KEEP ALIVE MEMORY RESET
KEO/KEOR TESTS
MODULE CALIBRATION
MODULE CONFIGURATION
SELECT ITEM AND PRESS TRIGGER TO START
d
3. NGS Mach II displays the selected action in
the Main menu:
1 )MODEL : 2008 CROWN VICTORIA
4.6L
2)MODULE: PCM -POWERTRAIN CONTROL
3)ACTION : EVAP TESTS
4)GO ->
SELECT ITEM AND PRESS TRIGGER TO START
d
To Begin a Test
Before beginning a test make sure the vehicle
selected is correct.
If you select a vehicle and
engine that doesn’t match the vehicle you’re
testing, your results may be incorrect.
To begin a test once the vehicle, module and
action are selected:
1. Highlight GO and then press TRIGGER.
1 )MODEL : 2008 CROWN VICTORIA
4.6L
2)MODULE: PCM -POWERTRAIN CONTROL
3)ACTION : EVAP TESTS
4)GO ->
SELECT ITEM AND PRESS TRIGGER TO START
d
Note: For non-CAN vehicles, you will be
prompted to reselect the following (press
TRIGGER after each selection):
• SELECT NEW VEHICLE YEAR & MODEL
• Select model year
• SELECT VEHICLE AND ENGINE
• Confirm selection
For detailed information on some of the
various tests, see their respective section
in this User Guide.
