70
9.4.3 Polar Coord. Measurement
The Polar coordinate measurement helps you to export polar
coordinates . The operate is below:
1. Select the „Polar Coord. Measurement‟ in Program menu.
2. Enter the information of station. Mention that the station
name must be defined while code can be left blank. Then,enter
the height of target and press „ENT‟ to save the settings ,after
that above,you can enter the interface of „Setup BBS‟
3. Enter the information of BBS. Mention that the BBS
name must be defined while code can be left blank. Enter the
height of target and press „ENT‟ to continue.
4.Aim at the BS following the prompt on the screen.As soon
as pressing „ENT‟ to finish setting up station, the instrument will
undertake a measurement automatically. Horizontal Angle is set
zero and a piece of data for edge and angle is saved.
5. After setting up station, you may stimulate process in
surveying to survey polar coordinates.
See process of setting up station and BBS in surveying.
Note: If right-angle buzz is on currently, it will buzzes
constantly after orientation. You can turn the instrument around
to close the buzz. Also you can switch the right-angle buzz off.
9.4.4 Coord.Z
Use the measured coordinate of known point to calculate
and reset the Z-coordinate of station .
The coordinates of known point can be called from
coordinate file or can be entered with keyboard. The operation is
as followed:
1. Prompt „Setup station‟ to ask you whether want to setup
station. Press „ENT‟ to setup.
2. Enter the „Coord.Z-No.1‟ page
To define „Coord.Z-No.1‟, follow the process of defining
BBS. Press „ENT‟ to confirm and end the dialogue to enter
„Coord.Z-No.1‟ measurement page.
Coord.Z-No.1
>Pt.name:
Code:
T.H: 0.000
[
★
]Select file
Input
K.Pt
Info.
M.Pt.