EN
4/70
3.3
Set rotor position ....................................................................................................................................................... 48
3.4
Start centrifugation .................................................................................................................................................... 49
3.5
Stop centrifugation..................................................................................................................................................... 49
3.6
How to store and recall programs ............................................................................................................................. 50
3.6.1
Recall program to edit:....................................................................................................................................... 50
3.6.2
Recall program and set this program active: ..................................................................................................... 50
3.6.3
Store program: ................................................................................................................................................... 50
3.6.4
Store program and set this program active: ..................................................................................................... 50
3.6.5
Write a new program and store it in the machine memory (EEPROM)............................................................. 51
3.6.6
Recall and activate an already stored program ................................................................................................. 52
3.7
Protocol Examples..................................................................................................................................................... 52
3.7.1
Sequence after starting PC communcation ....................................................................................................... 53
3.7.2
Cyclic enquiry during standstill and positioning:................................................................................................ 54
3.7.3
Change the Nominal Values in stand still or during the run .............................................................................. 55
3.7.4
The PC writes a program which will be stored in the centrifuge........................................................................ 56
3.7.5
The PC recalls and activates a program ........................................................................................................... 56
3.7.6
Open the hatch .................................................................................................................................................. 57
3.7.7
Set Rotor target rotor position 1......................................................................................................................... 57
3.7.8
Set target rotor position 4 .................................................................................................................................. 58
3.7.9
Close the hatch .................................................................................................................................................. 58
3.7.10
Recall Program No 6...................................................................................................................................... 58
3.7.11
Start centrifugation......................................................................................................................................... 59
3.7.12
Stop centrifugation ......................................................................................................................................... 59
3.7.13
Wait for standstill and the automatical position 1 and terminate positioning................................................. 60
3.8
Rotor cycles commands ............................................................................................................................................ 60
3.8.1
General description............................................................................................................................................ 60
3.8.2
Cycle counter ..................................................................................................................................................... 60
3.8.3
Check the general information about the "conditions" of rotor cycle counter.................................................... 61
4
Comparison between the serial communication Generation 1 and Generation 2 ............................................................ 63
4.1
The serial protocol (hardware, settings and telegrams) remain constant. ................................................................ 63
4.2
Brief introduction of the differences:.......................................................................................................................... 63
4.3
List of parameters:..................................................................................................................................................... 63
5
Communication with Generation 2 according to the still valid communication of Generation 1....................................... 67
5.1
Open the hatch .......................................................................................................................................................... 67
5.2
Go to position 1 and check the reached position ...................................................................................................... 67
5.3
Go to position 2 and check the reached position ...................................................................................................... 67
5.4
Go to position 3 and check the reached position ...................................................................................................... 68
5.5
Go to position 4 and check the reached position. ..................................................................................................... 68
5.6
Close the hatch.......................................................................................................................................................... 68
5.7
Start the centrifuge! ................................................................................................................................................... 69
5.8
STOP per PC = Emergency stop .............................................................................................................................. 69
5.9
Cancel Software-lock LOCK 4 or LOCK 5................................................................................................................. 69
5.10
Change the Nominal Values in stand still or during the run .................................................................................. 70
5.11
Recall (RCL) a program stored in the control panel, ready to start....................................................................... 70
5.12
Change and store the values of a program ........................................................................................................... 70
