Herz BioFire 1000, Operating Instructions Manual

Page: 31 / 98

Menu navigation and adjustment values 9
31
Term Description Unit
Reci mixing temperature
(if flue gas recirculation is
activated)
Display of the mixing temperature as well as the output of the Reci flap
control
°C / %
Exhaust Gas
Recirculation*
Display the Exhaust gas recirculation (RECI) %
Status 3
1 2
3
4
Primary air 1 - Top Display of the current value of the PRIMAIR 1 upper %
PRIMAIR 2 under Display of the current value of the PRIMAIR 2- under %
SECAIR 1 Display of the current value of the SECAIR 1 %
SECAIR 2 Display of the current value of the SECAIR 2 %
Insertion Indicates the state of the insertion -
O2 [%] Display of the actual O
2
-content (oxygen content) in the flue gas %
CO2 [%] Display of the actual CO
2
-content (carbon dioxide content) in the flue gas %
Status 4 (optional)
1 2 3
4
Temperature 1 - 4 Display of the actual walking floor temperature (optional via CAN) °C
Menu
„Settings“ (System specific)
Settings 1 1
2 3
Residual heat temperature
Setting up the residual heat temperature (20-75) e.g.: minimum boiler
temperature after fuel burnout, when (at the latest) return flow pump gets
turned off.
°C
Control hysteresis
Setting up the control hysteresis (3-20). Is the temperature above which
the required boiler temperature is regulated.
°C
Waiting period
The transfer of the demand to the boiler is delayed by the set time (0-
240min).
min
HEC-barrier time No heat exchanger cleaning takes place in the set time.
00:00-
23:59
current fuel Setting the current fuel (wood chips / pellets) -
Setting a custom fuel (wood chips I, wood chips II,...) -
Overview of work / pause / primary air 1-2 / secondary air 1-2 in tabular
form
-
Settings 2
1
2
3
Variant 1
If “weather-related performance management" is not activated.
-
Power max
Setting up the maximum boiler power (30-100). Enable boiler power
regulation (limitation) (Only if “weather-related performance management"
is not activated.)
%
Variant 2
If “weather-related performance management" is activated.
-
Outside temp. sensor
Selection of the outside temperature sensor
If multiple outside temperature sensors are installed, the desired outside
temp. sensor can be assigned to the chosen heating circuit.
-
Balancing outside sensor
Adjusting the balancing of the outside temperature (± 5):
Shows the outside sensor not the correct outside temperature, the value
can be adjusted.
°C
Actual outside
temperature
Indicates the actual outside temperature.
°C