Servicing the device
46
Exchanging the defective flash tube with protection
glass
The flash tube is located in the protection glass and must always be
exchanged together with the protection glass.
DANGER
If the flash tube with protection glass is defective, the
electrodes are exposed. Touching the flash tube may result
in an electric shock.
Switch off the device.
Disconnect the device from the power mains.
Before touching the defective flash tube with protection
glass, wait for 3 hours to allow the capacitor voltage in
the device to drop.
If the flash tube with protection glass is broken, do not
touch the electrodes under any circumstance. Always
use pliers with protective insulation to remove the flash
tube with protection glass.
To install the flash tube with protection glass, proceed as follows:
Switch off the device at the main switch.
Remove the mains cable (see page 31).
Wait for 3 hours.
Remove the light shaping tool (see page 29).
Dismantle the flash tube with protection glass (see page 26).
If necessary, remove all glass fragments of the flash tube with
protection glass.
Remove the new flash tube with protection glass from the packaging.
Make sure the glass body of the new flash tube is not defective.
Mount the flash tube with protection glass (see page 26).
Mount the light shaping tool (see page 29).
Connect the mains cable (see page 31).
Switch on the device at the main switch.
Summary of Contents for Certo 200
Page 56: ......