Henny Penny KVE-071, Operator'S Manual

Page: 52 / 56

March 2019 44
Problem Cause Correction
Oil foaming or boiling
over top of vat
• Water in oil
• Improper or bad oil
• Improper filtering
• Improper rinsing after clean-
ing the vat
• Drain and clean oil
• Use recommended oil
• Refer to filtering procedures
• Clean and rinse vat and then dry thor-
oughly
Oil will not
drain from vat
• Drain valve clogged with
crumbs
• Drain trough clogged
• Open valve, use straight white brush to
force crumbs through drain valve
Do not leave brush in drain valve.
• Remove right side panel and remove plug
from end of trough and clean trough
Filter motor runs but
pumps oil slowly
• Filter line connections loose
• Filter paper or pad clogged
• Tighten all filter line connections
• Change filter paper or pad
Bubbles in oil during
entire filtering process
• Filter pan not completely
engaged
• Filter pan clogged
• Damaged O-ring on filter line
receiver on fryer
• Make sure filter pan return line is pushed
completely into the receiver on the fryer
• Clean pan and change paper or pad
• Change O-ring
Control error code “E-31” • Elements are up • Lower elements back into vat
Filter motor will not run • Power cord for vat #1 is not
plugged-in
• Open circuit
• The thermal reset button on
the rear of the pump motor is
tripped
• Plug power cord into receptacle
• Breakers in fryer tripped-open left door
and reset breaker on fryer
• Allow time for the motor to cool; Using a
screwdriver, press hard against the button
until it clicks
7-1
TROUBLE SHOOTING GUIDE
(CONT.)