Henny Penny Evolution Elite EEG-16 Series, Technical Manual

Page: 41 / 98

Level
2
Programming
29
• T-17 Inputs
• T-18 Outputs S-H-S-H
• T-19 Basket Lifts
• T-20 AIF Info
• T-21 Pumps and Valves
• T-22 Recovery Test Valves
• T-23 Heat Err Enabled?
• T-24 Change Tech Code?
• T-25 Total Initialization
NOTE: Not all Tech Mode functions are discussed in this section. To ensure proper
operation of fryer, please consult Henny Penny Corp. before changing any of these
settings. For more information on these functions, contact the Service Department at
1-800-417-8405, or 1-937-456-8405.
1 1))
Press and hold the program button for 5 seconds until “LEVEL 2”, followed by,
“SP PROG” and “ENTER CODE” show in the display.
2 2))
Press the program button 4 times and “TECH” and “ENTER CODE” flash in the
left display.
3 3))
Enter code 1, 1, 2, 2, 1, 1, 2, 2 (first 2 product buttons).
4 4))
“T-1 SOFTWARE” flashes in the left display and “EV-ELITE” shows in the right
display. Use the left and right arrows to select the steps.
NOTE: If a bad code is entered, a tone sounds and “BAD CODE” shows on the
display. Wait a few seconds, the controls revert back to the cook mode, and repeat
the above steps. Press and hold the program button at anytime to return to normal
operation.
5 5..4 4..1 1 T T--1 1 -- S So offttw wa arre e
• Press product button 1 to view HP Part No. of eprom.
• Press product button 2 to view software ID.
• Press product button 3 to view software version.
5 5..4 4..2 2 T T--3 3 -- P Pu ussh h--B Bu utttto on n T Te esstt
1 1))
Press any of the control buttons to test operation. You should hear a beep, and
the LED should light and/or a display.
5 5..4 4..3 3 T T--4 4 -- A Allll O On n D Diissp plla ayy T Te esstt
1 1))
Press any of the product buttons and all the LEDs and display segments should
light.
5 5..4 4..4 4 T T--5 5 -- S Se eg gm me en nttss T Te esstt
1 1))
Press the timer 1 button to view the different segments of the display characters.