![Henny Penny Evolution Elite EEG-16 Series Technical Manual Download Page 16](http://html1.mh-extra.com/html/henny-penny/evolution-elite-eeg-16-series/evolution-elite-eeg-16-series_technical-manual_2124329016.webp)
4
Display
Cause
Panel Board Correction
Flue or hood
obstruction.
Check the fryer flue and hood system for obstructions.
“E-20-D"
“IGNITION
FAILURE”
Failure to ignite/
no flame sense.
Press power button to vat off and back on again, if E-20-D
persists, check gas line connections; check gas shut-off
valve; have ignition module checked; gas valve checked;
flame sensor gap checked; gas valve and ignition module
wiring checked.
Plugged atmos-
pheric equaliza-
tion hole in
regulator cap re-
sulting in pilot
flame slowly
fading.
Clear obstruction from hole.
“E-21”
Slow heat
recovery.
Have a certified service technician check the fryer for cor-
rect voltage to the unit; have heat circuit checked; have
unit checked for loose or burnt wires.
“E-22”
”NO HEAT”
“CHECK
GAS
VALVE”
Burner not
igniting.
Have gas valve and heat circuit checked.
“E-41”
“E-46”
Programming
failure.
Turn power switch to vat off, then back to on; if display
shows an error code, have the controls re-initialized; if er-
ror code persists, have the control board replaced.
“E-47”
Analog converter
chip or 12-volt
supply failure.
Turn power switch to vat off, then back to on; if “E-47” per-
sists, have the I/O board, or the PC board replaced; if
speaker tones are quiet, probably I/O board failure; have
the I/O board replaced.
“E-48”
Input system
error.
Have PC board replaced.
“E-54C”
Temperature in-
put error.
Turn power switch to off, then back to on; have control PC
board replaced if “E-54C” persists.
“E-60”
“FILTER IN
USE”
AIF PC board not
communicating
with PC board.
Turn power switch to off, wait 15 seconds, then turn switch
back to on. If “E-60 persists, have connector between the
PC boards checked; replace AIF PC board or control PC
board if necessary.
“E-70C”
Drain valve jump-
er wire missing or
disconnected.
Have the jumper wire checked on the PC board at drain
switch interlock position.
“E-82–D”
Selector Valve
Failed
No activity is detected. Check motor encoder, selector
valve motor, and AIF board.
Summary of Contents for Evolution Elite EEG-16 Series
