HelmPak Press Control
6
Users Guide
REPLACING MODULES
Do not remove modules under power.
The module location in a specific rack is critical to proper operation of the Helm-Pak press control. If a
module is replaced, ensure that the proper module is inserted into the proper slot in the rack. If it is not
the ladder programming will not recognize the module and the Helm-Pak control will become unstable
and unsafe to operate.
TURNING
SYSTEM
ON
SAFETY FIRST
Check all light curtains, barriers, safety shields and
personnel safety devices to ensure that they are present and functioning
properly. If they are not, do not proceed with starting the press. Authorized
personnel should make any repairs that are required before starting the press.
Always wear eye and ear protection when operating a stamping press.
