HelioSphera HS Atlas Series, Safety And Installation Instructions Manual

Page: 9 / 51

10-SSI-001_rev.005_ENG
Page 9 of 51
The modules are qualified for application class A: Hazardous voltage (IEC 61730: higher
than 50V DC: EN 61730: higher than 120V), hazardous power applications (higher than 240W)
where general contact access is anticipated (Modules qualified for safety through EN IEC
61730-1 and -2 within this application class are considered to meet the requirements for safety
class II).
Danger electric shock risk
4.3 Fire Safety
HS modules have a Class E Fire Rating and must be installed over a roof of appropriate
fire resistance. Consult your local building department to determine approved roofing materials.
Do not use modules near equipment or locations where flammable gases can be
generated or collected.
Fire codes vary widely, but in general require a minimum number of access paths so that
fire brigades can fight fires and ventilate the structure. Check with local authorities before
designing a project.
4.4 Hazardous Locations
The modules are not suitable for installation in potentially explosive or flammable
environments. The modules should not be installed at the following locations:

Near sources of flammable gases and vapors, such as gas/petrol stations, gas storage
containers, spray paint facilities.

Near open flames.