Heinzinger electronic GmbH
Phone: +49 (0) 8031 2458 0
www.heinzinger.com
Anton-Jakob-Str. 4, 83026 Rosenheim
Fax: + 49 (0) 8031 2458 58
Germany
Page 59
ERS COMPACT
Group
Parameters & description
Reset / Restart
Reset device to defaults
This touch area will initiate a reset of all settings (HMI, profile etc.) to factory default.
Restart
Triggers a warm start
3.5.3.2
Sub menu “Profiles”
See
“3.10 Loading and saving user profiles” on page 80.
3.5.3.3
Sub menu “Overview”
This menu page displays an overview of the set values (U, I, P or U, I, P, R), device alarm thresholds, event set
-
tings, adjustment limits,
as well as an alarm history which lists the number of device alarms that occurred since
the device has been powered.
3.5.3.4
Sub menu “About HW, SW, ...”
This menu page displays an overview of device relevant data such as serial number, article number etc.
3.5.3.5
Sub menu “Function Generator”
See
“3.11. The function generator”.
3.5.3.6
Sub menu “Communication”
This sub menu offers settings for digital communication via the built-in interfaces USB and Ethernet and also for
the optional interface modules of IF-AB series.
There is furthermore an adjustable communication timeout for USB or RS232, to make it possible to successfully
transfer fragmented messages (data packets) using higher values. In group “
Protocols
” you can disable one of
the two supported communication protocols, ModBus and SCPI. This can help to avoid mixing both protocols and
to receive unreadable messages, for example when expecting a SCPI response and getting a ModBus response
instead.
The USB itself doesn’t require any settings. The device will have following default Ethernet port related settings
which are listed in group “
Ethernet (internal)
”:
IF Settings
Description
Ethernet (internal)
DHCP
The IF allows a DHCP server to allocate an IP address, a subnet mask and a gateway. If
no DHCP server is in the network then network parameters will be set as defined below.
IP address
Manually allocate an IP address.
Subnet mask
Manually allocate
a subnet mask.
Gateway
Manually allocate
a gateway address
,
if required.
DNS address
Manually allocate addresses of a Domain Name Server (DNS), if
required.
Port
Select port in the range 0...65535. Default:
5025
Reserved ports: 502, 537
Host name
User definable host name
Domain
User definable domain
Settings for the optional interface modules (IF-AB-xxx)
IF Settings
Description
CANopen
Baud Rate
CAN bus baud rate selection that is used by the CANopen interface.
Auto
= Automatic detection
LSS
= Baud rate and node address are assigned by the bus master
Fixed baud rates:
10 kbps
,
20 kbps
,
50 kbps
,
100 kbps
,
125 kbps
,
250 kbps
,
500 kbps
,
800 kbps
,
1Mbps
Node Address
Selection of the CANopen node address in the range
1
...
127