Heiniger 708-600, Translation Of The Original Instructions

Page: 36 / 240

18
Translation of the original instructions / Cattle and horse clipper
Malfunction Cause Rectification
No speed difference
between level I and
level II
Faulty motor and / or electronics Notify customer service.
Lowest LED on charger
is not lit.
Charging station is not connected
to the power supply.
Connect the charging station
to the power supply.
Electronics or power supply unit
defective.
Notify customer service.
Normal charging does
not start when the
discharged battery is
inserted.
Battery terminals and/or charger
are dirty.
Clean contacts.
Faulty battery. Replace battery.
Electronics are defective. Notify customer service.
Bottom LED lights up
green.
Battery is deeply discharged, the
charger is trying to boost the batte-
ry voltage.
If it is successful, normal
charging starts. (Never store
batteries in the discharged
state).
If it is not successful, the lowe-
st LED lights up red (see the
following table).
Top LED lights up red. Faulty battery. Replace battery.
8 Spare parts
See spare parts list at the end of these operating instructions.
CAUTION!
FAULTY SPARE PARTS MAY CAUSE DAMAGES, MALFUNCTIONS OR TOTAL
LOSS AND MAY REDUCE SECURITY.
X
Use only original spare parts from the manufacturer. Obtain spare parts from an
authorised dealer or directly from the manufacturer.
NOTE!
If non-approved parts are used, all warranty, service, compensation and liability claims
against the manufacturer or its employees, dealers and representatives will be forfei-
ted.
During the warranty period the device must be opened only by personnel authorised by the ma-
nufacturer, otherwise the warranty will be void.
Pos.
No.
Description Quan-
tity
Pos.
No.
Description Quan-
tity
Clipper 30 Upper housing cover 1
1 Clipper head cattle complete 1 31 Switch lever 1
2
Tension nut cattle 1 32 Switch detent with switch
contact
1
3 Distance screw 1 33 Lower housing cover 1
4 Tension sleeve 1 34 Motor holder 1
5 PH screw M5x14 2 36 Battery Li-Ion 1
6 Clipper head case 1 37 PCB for machine 1
7 Pressure spring 1 38 Switch contact 1
8 Pressure plate 1 39 PH screw M3x6 2