Issued September 2017
Introduction
Copyright 2017, Heil Environmental
Printed in U.S.A.
23
PRODUCT NOMENCLATURE (CONTINUED)
Throttle Advance
– There are two standard and an additional switch when there is a lifting option (winch, etc.) installed,
The primary switch is in the cab and must be set to ON for the outside switch(es) to operate. The second standard switch
is next to the tailgate and ejector panel controls at front, street side of the body. The switch allows the operator to increase
the RPMs of the engine which delivers more hydraulic flow for raising the tailgate and extending the ejector panel while
pushing refuse out of the body.
A third throttle advance switch is located on the curb side of the tailgate when there is an optional lift device. The operator
uses the switch to increase hydraulic flow while raising a commercial refuse container with a winch, reeving mechanism,
an arm mechanism or a roll bar.
The throttle advance is automatically engaged during the tailgate packing cycle.
Winch Assembly
– The winch assembly includes a winch, an attached cable with hook and controls. This option allows
an operator to load refuse from a commercial refuse container into the hopper. The controls will be located on the rear,
curb side of the unit.
Summary of Contents for PT 1000
