Issued September 2017
On-Route Operation Procedures
Copyright 2017, Heil Environmental
Printed in U.S.A.
118
LOADING REFUSE WITH A WINCH
(CONTINUED)
e. After the refuse container is empty of refuse,
PUSH the control lever for the winch until the
refuse bin rests firmly on the ground and there is
enough slack in the cable to remove the cable
hook from the refuse container.
f. Remove the cable hook and attach it to the eye
on the tailgate.
g. PULL the control lever for the winch mechanism
until the cable tightens and secures the hook in
the eye on the tailgate.
h. RELEASE the container’s trunnion bar from the
.
i.
MOVE the container to its pick-up location.
j.
Sweep the refuse from the hopper and pack it into
the body.
3. Sweep the refuse from the hopper and pack it into
the body.
a. PULL the slide and blade levers at the same time
and RELEASE the levers. The levers will self-
center at the end of the commanded position by
way of valve internal hydraulic pressure. See
.
b. The slide will move OUT and the blade will move
UP. STOP the blade UP operation when the blade
is at the pinch point with the hopper sill.
c. Watch for refuse that is pushed out of the hopper.
d. PUSH the slide and blade levers at the same time
and RELEASE the levers. The levers will self-
center at the end of the commanded position by
way of valve internal hydraulic pressure. See
Loading Refuse Manually (Continued)
.
4. The slide and blade move and compact the refuse
into the body.
5. Repeat Steps 1 and 3 as necessary to compact the
refuse.
6. Leave the blade against the refuse.
131
109
109
Summary of Contents for PT 1000
