26
Rev. 05/2020
Lighting the HEATMOR™ for the First Time
When lighting the HEATMOR™ furnace for the first time, all installations must be complete
and the furnace must be full of Heat Transfer Fluid (HTF). Use the following steps simply
as a guideline or contact your local dealer for further instruction.
Read the entire manual
before lighting, so you have a complete working knowledge of the furnace.
Ask for a
demonstration from your local dealer
.
It is very important to fully educate all persons
who will be lighting and fueling the HEATMOR™ furnace.
1) Confirm the furnace is full of HTF
2) Open bladder valve.
3) Confirm there is 115-volt electrical power supplying the HEATMOR™ furnace.
4) Place some small pieces of wood (five pounds) with paper into the firebox.
5) Place a few larger pieces of wood (20 pounds) on top of the smaller pieces.
6) Light the fire.
7) Leave the fire box door partially open to allow the fire to start burning. The firebox
door should only need to be open about two inches. At this point the smoke should
go up the chimney and not out the firebox door.
8) Once the fire is burning rather briskly, close the fire box door and turn off the light
switch which in turn will make the combustion air blower(s) operate.
9) Operate the blowers for approximately 10 minutes.
10) Turn off the blowers. Wait a few seconds to allow the combustion to decrease.
11) Open the firebox door and add a substantial amount of wood to the firebox.
12) Turn on the blowers.
13) Securely close the firebox door and outer door.
