16
Rev. 05/2020
Electrical
1) Do not connect the electrical components of the HEATMOR™ Outdoor Furnace to
any other electrical appliance.
2) This HEATMOR™ Outdoor Furnace operates on 115-volt power only. Do not connect the
furnace to a 220-volt electrical supply.
3)
HEATMOR™ recommends a licensed professional electrician make all the
necessary electrical connections involved with the installation of the furnace.
4) Always disconnect the HEATMOR™ Outdoor Furnace from the main electrical supply
before servicing any of the electrical components of the HEATMOR™ Outdoor
Furnace.
5) Always disconnect any existing electrical connections to any in-house heating system,
before installing the outdoor furnace to any existing indoor heating system or
appliances.
6)
The red wire from the New Style High-Limit on the back of the
HEATMOR™ should be wired to the indoor temperature control to
override the thermostat. This will dissipate excess heat in the event of
a possible malfunction with the HEATMOR™ (The red wire is capped
off in the electrical junction box when the HEATMOR™ is new.)
Other
The unit may be connected to an existing indoor boiler system by installing a
water-to-water heat exchanger.
1) HEATMOR™ recommends that you contact a licensed professional plumber to
make all necessary plumbing installations between the HEATMOR™ furnace and
the existing heating system of your building(s).
2) Do not operate the HEATMOR™ furnace until all electrical and water line
connections have been properly installed and tested.
3)
Do not allow any fire in the firebox until the HEATMOR™ has the correct amount
of Heat Transfer Fluid (HTF) and sand installed.
4)
Absolutely no fire in the firebox when performing any repair. Do not perform this
repair when unit HTF temperature is unsafe. Always wear proper personal
protective equipment when working with HTF and chemicals.
