Heatilator • HEIR36, HEIR42, HEIR50 Installation Manual • 2285-980 Rev. G • 12/14
42
TOP FINISHING
TEMPLATE
SIDE FINISHING
TEMPLATES
B. Finishing Templates
Two side
fi
nishing templates and one top
fi
nishing
template are supplied with the appliance. Refer to the
decorative front instructions for template removal.
INSIDE FIT Method: The
fi
nishing template pieces are
required for installations that require more than one inch
thick
fi
nishing materials to be installed over the face of the
factory-supplied 1/2 inch non-combustible board. Refer
to section 10.D for more information.
OVERLAP Method: The supplied templates are not
required for
fi
nishing materials less than one inch thick.
The required decorative front will overlap
fi
nish materials
less than one inch thick. Refer to section 10.D for more
information. Remove template by removing the the two top
screws and two screws on each side. The glass assembly
will need to be removed to access the side screws. Follow
the glass removal instructions in Section 11.
Arch Decorative Front Application:
If an arch
decorative front option is chosen, an Arch Template
Kit is required to be installed prior to the installation of
the decorative
fi
nishing materials. This kit includes new
fi
nishing templates (3) and arch corner
fi
ll pieces (2).
Contact your dealer to order the correct Arch Template Kit
for your
fi
replace model.
Figure 10.3 Left and Right Side Finishing Template Bends
Figure 10.4 Top and Side Finishing Template Locations
Figure 10.2 Top Finishing Template Bend
1-1/4 IN.
TAB
3/4 IN.
